GS-3012/GS-3012F User’s Guide
215
CHAPTER 26
Static Route
This chapter shows you how to configure static routes.
26.1 Static Routing Overview
The Switch uses IP for communication with management computers, for example using
HTTP, telnet, SSH, or SNMP. Use IP static routes to have the Switch respond to remote
management stations that are not reachable through the default gateway. The Switch can also
use static routes to send data to a server or device that is not reachable through the default
gateway, for example when sending SNMP traps or using ping to test IP connectivity.
This figure shows a Tel n e t session coming in from network N1. The Switch sends reply traffic
to default gateway R1 which routes it back to the manager’s computer. The Switch needs a
static route to tell it to use router R2 to send traffic to an SNMP trap server on network N2.
Figure 121 Static Routing Overview
26.2 Configuring Static Routing
Click IP Application > Static Routing in the navigation panel to display the screen as shown.
R1
R2
N1
N2
SNMP
Telnet
To Next Page
Loading...
