ZyXEL Communications GS-3012F/3012 - Chapter 5 Initial Setup Example; Overview; Creating a VLAN; Figure 24 Initial Setup Network Example: VLAN

GS-3012/GS-3012F User’s Guide
59
CHAPTER 5
Initial Setup Example
This chapter shows how to set up the Switch for an example network.
5.1 Overview
The following lists the configuration steps for the initial setup:
• Create a VLAN
• Set port VLAN ID
• Configure the Switch IP management address
5.1.1 Creating a VLAN
VLANs confine broadcast frames to the VLAN group in which the port(s) belongs. You can
do this with port-based VLAN or tagged static VLAN with fixed port members.
In this example, you want to configure port 1 as a member of VLAN 2.
Figure 24 Initial Setup Network Example: VLAN