ZyXEL Communications LTE3311 series - Page 6

66
• The WLAN/WPS light stays on and green when the 2.4GHz band
wireless LAN is ready. The light will not turn on if the wireless
connection is not activated. It blinks orange per 0.5 seconds after
you press the WPS button. The process takes up to 2 minutes within
which you can add a WPS-enabled device to the wireless network.
See the User’s Guide for more information.
• The PHONE light is green when a SIP account is registered for the
phone port. It blinks green when there is an incoming call or a
telephone connected to the phone port has its receiver off of the
hook. The PHONE light is orange when a SIP account is registered
for an outgoing call and there is a voice message in the
corresponding SIP account. It blinks orange when a telephone
connected to the phone port has its receiver off of the hook and
there is a voice message in the corresponding SIP account. It is off
when the phone port does not have a SIP account registered or the
LTE3311 is not receiving power.
• The USB light is green when the LTE3311 has a USB device
installed. It blinks green when the LTE3311 is transmitting and/or
receiving data from routers. It is off when there is no USB device
connected to the LTE3311.
If the POWER light does not turn on during start up, disconnect the LTE3311’s
power, check the connections, wait a few seconds and connect it again. If the
problem persists, you may have a hardware problem and you need to contact your
vendor.