ZyXEL Communications NAP Series - Page 33

Chapter 5 Maintenance
NAP Series User’s Guide
33
Figure 23 Maintenance > Log > View Log
The following table describes the labels in this screen.
Table 14 Maintenance > Log > View Log
LABEL DESCRIPTION
Show Filter / Hide
Filter
Click this button to show or hide the filter settings.
If the filter settings are hidden, the Display, Email Log Now, Refresh, and Clear Log fields are
available.
If the filter settings are shown, the Display, Priority, Source Address, Destination Address, Source
Interface, Destination Interface, Protocol, Keyword, and Search fields are available.
Display Select the category of the log messages you want to view. You can also view All Logs or view
the Debug Log.
Priority Select the priority of log messages to display. The log displays the log messages with this priority
or higher.
Possible values from highest priority to lowest priority are:
•any
• emerg (emergency)
•alert
• crit (critical)
•error
• warn (warning)
• notice
• info (information)
Note: This field is read-only if Display is set to Debug Log.
Source Address Type the source IP address of the incoming packet that generated the log message. Do not
include the port in this filter.