Chapter 1 Introduction
NAP Series User’s Guide
12
Figure 4 NAP102 LED
The following are the LED descriptions for your NAP102.
Table 3 NAP102 LED
COLOR STATUS DESCRIPTION
Red Slow Blinking (On for 1s,
Off for 1s)
The NAP is booting up.
Green On
Red Off The NAP is ready for use.
Green On
Red Off The NAP’s wireless interface is activated.
Green On
Red Slow Blinking (blink for 3
times, Off for 3s)
The NAP is searching for (discovering) the NCC.
Green On
Red Off The NAP is connected to the NCC, but not registered.
Green Slow Blinking (On for 1s,
Off for 1s)
Red On The NAP failed to boot up or is experience system failure.
Green Off
Red Fast Blinking (On for
50ms, Off for 50ms)
The NAP is undergoing firmware upgrade.
Green Off
Red Slow Blinking (blink for 3
times, Off for 3s)
The Uplink port is disconnected.
Green Off
To Next Page
Loading...
