Chapter 1 Introduction
NAP Series User’s Guide
10
1.5.2 NAP203
The LEDs will stay ON when the NAP203 is ready. You can change this setting through the NCC (Nebula
Control Center).
Figure 3 NAP203 LEDs
The following table describes the LEDs.
Table 2 NAP203 LEDs
LED COLOR STATUS DESCRIPTION
PWR/SYS Red Slow Blinking (On for 1s,
Off for 1s)
The NAP is booting up.
Green On
Red Off The NAP is ready for use.
Green On
Red On There is system error and the NAP cannot boot up, or the
NAP suffered a system failure.
Green Off
Red Fast Blinking (on for
50ms, Off for 50ms)
The NAP is undergoing firmware upgrade.
Green Off
Red Slow Blinking (blink for 3
times, Off for 3s)
The Uplink port is disconnected.
Green Off
Red Slow Blinking (blink for 2
times, Off for 3s)
The wireless module of the NAP is disabled or failed.
Green Off
Management Green On The NAP is managed by the NCC.
Slow Blinking (On for 1s,
Off for 1s)
The NAP is connected to the NCC, but not registered.
Amber Slow Blinking (blink for 3
times, Off for 3s)
The NAP is searching for (discovering) the NCC.
To Next Page
Loading...
