Chapter 1 Introduction
NAP Series User’s Guide
9
The following table describes the LEDs.
Table 1 NAP303 LEDs
LED COLOR STATUS DESCRIPTION
PWR/SYS Red Slow Blinking (On for 1s,
Off for 1s)
The NAP is booting up.
Green On
Red Off The NAP is ready for use.
Green On
Red On There is system error and the NAP cannot boot up, or the
NAP suffered a system failure.
Green Off
Red Fast Blinking (on for
50ms, Off for 50ms)
The NAP is undergoing firmware upgrade.
Green Off
Red Slow Blinking (blink for 3
times, Off for 3s)
The Uplink port is disconnected.
Green Off
Red Slow Blinking (blink for 2
times, Off for 3s)
The wireless module of the NAP is disabled or failed.
Green Off
Management Green On The NAP is managed by the NCC.
Slow Blinking (On for 1s,
Off for 1s)
The NAP is connected to the NCC, but not registered.
Amber Slow Blinking (blink for 3
times, Off for 3s)
The NAP is searching for (discovering) the NCC.
WLAN Green On The 2.4 GHz WLAN is active.
Off The 2.4 GHz WLAN is not active.
WLAN Green On The 5 GHz WLAN is active.
Off The 5 GHz WLAN is not active.
UPLINK Amber/
Green
On Amber - The port is operating as a 100-Mbps connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The NAP is sending/receiving data through the port.
Off The port is not connected.
LAN Amber/
Green
On Amber - The port is operating as a 100-Mbps connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The LAN port is sending/receiving data through the port.
Off The LAN port is not connected.
Locator White Blinking The Locator is activated and will show the actual location
of the NAP between several devices in the network.
Off The Locator function is off.
To Next Page
Loading...
