Chapter 2 Hardware
NBG7510 User’s Guide
24
3 If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the full
depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way in – leave
a small gap of about 0.5 cm. If not using screw anchors, use a screwdriver to insert the screws into the
wall. Do not insert the screws all the way in - leave a gap of about 0.5 cm.
Figure 12 Wall Mounting Anchors
4 Make sure the screws are fastened well enough to hold the weight of the Zyxel Device with the
connection cables.
5 Align the holes on the back of the Zyxel Device with the screws on the wall. Hang the Zyxel Device on
the screws.
Figure 13 Wall Mounting Device
To Next Page
Loading...
