Chapter 2 Hardware
NBG7510 User’s Guide
23
2.4 Wall Mounting
Please refer to the installation guide below for the wall mounting procedures of the Zyxel Device. You
may need screw anchors if mounting on a concrete or brick wall.
Figure 10 Wall Mounting Screw Specifications
Do the following to attach your Zyxel Device to a wall.
1 Select a position free of obstructions on a wall strong enough to hold the weight of the Zyxel Device.
2 Mark two holes on the wall at the appropriate distance apart for the screws.
Figure 11 Wall Mounting Distance
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
Do not wall mount the Zyxel Device over a height of 2 m.
Table 4 Wall Mounting Information
Distances between holes 105 mm
M4 Screws Two
Screw Anchors Two
To Next Page
Loading...
