Chapter 22 Troubleshooting
NWA / WAC Series User’s Guide
212
• Turn the NWA1123-AC PRO or WAC6103D-I indoor AP counter-clockwise to detach it from the
mounting bracket.
22.6 Resetting the NWA/WAC
If you cannot access the NWA/WAC by any method, try restarting it by turning the power off and then
on again. If you still cannot access the NWA/WAC by any method or you forget the administrator
password(s), you can reset the NWA/WAC to its factory-default settings. Any configuration files or shell
scripts that you saved on the NWA/WAC should still be available afterwards.
Use the following procedure to reset the NWA/WAC to its factory-default settings. This overwrites the
settings in the startup-config.conf file with the settings in the system-default.conf file.
Note: This procedure removes the current configuration.
To Next Page
Loading...
