Chapter 1 Introduction
NWA / WAC Series User’s Guide
33
Figure 10 NWA1123-AC HD, NWA5123-AC HD and WAC6303D-S LED
The following are the LED descriptions for your NWA/WAC.
1.7 Starting and Stopping the NWA/WAC
Here are some of the ways to start and stop the NWA/WAC.
Table 13 NWA1123-AC HD, NWA5123-AC HD and WAC6303D-S LED
COLOR STATUS DESCRIPTION
Amber Slow Blinking (On for 1s,
Off for 1s)
The NWA/WAC is booting up.
Green On
Amber Slow Blinking (blink for 3
times, Off for 3s)
The NWA/WAC is discovering an AP controller.
Green On
Green On The NWA/WAC is ready for use, the NWA/WAC’s wireless interface is
activated, and/or wireless clients are connected to the NWA/WAC.
Bright Blue On The NWA/WAC’s wireless interface is activated, but there are no wireless
clients connected.
Red On The NWA/WAC failed to boot up or is experience system failure.
Red Fast Blinking (On for
50ms, Off for 50ms)
The NWA/WAC is undergoing firmware upgrade.
Red Slow Blinking (blink for 3
times, Off for 3s)
The Uplink port is disconnected.
Green Slow Blinking (blink for 1
time, Off for 1s)
The wireless LAN is disabled or fails.
Blue Slow Blinking (blink for 1
time, Off for 1s)
The NWA/WAC is checking for an available 5GHz channel.
To Next Page
Loading...
