Chapter 8 AP Profile
NWA5000 / WAC6500 Series User’s Guide
95
Radius Server Type This shows External and the NWA/WAC uses an external RADIUS server for
authentication.
Primary /
Secondary Radius
Server Activate
Select this to have the NWA/WAC use the specified RADIUS server.
Radius Server
IP Address
Enter the IP address of the RADIUS server to be used for authentication.
Radius Server
Port
Enter the port number of the RADIUS server to be used for authentication.
Radius Server
Secret
Enter the shared secret password of the RADIUS server to be used for authentication.
Primary /
Secondary
Accounting Server
Activate
Select the check box to enable user accounting through an external authentication
server.
Accounting
Server IP
Address
Enter the IP address of the external accounting server in dotted decimal notation.
Accounting
Server Port
Enter the port number of the external accounting server. The default port number is
1813. You need not change this value unless your network administrator instructs you
to do so with additional information.
Accounting
Share Secret
Enter a password (up to 128 alphanumeric characters) as the key to be shared between
the external accounting server and the NWA/WAC. The key must be the same on the
external accounting server and your NWA/WAC. The key is not sent over the network.
802.1X Select this to enable 802.1x secure authentication.
ReAuthenticatio
n Timer
Enter the interval (in seconds) between authentication requests. Enter a 0 for unlimited
requests.
WEP Authentication Settings
Idle Timeout Enter the idle interval (in seconds) that a client can be idle before authentication is
discontinued.
Authentication Type Select a WEP authentication method. Choices are Open or Share key. Share key is
only available if you are not using 802.1x.
Key Length Select the bit-length of the encryption key to be used in WEP connections.
If you select WEP-64:
• Enter 10 hexadecimal digits in the range of “A-F”, “a-f” and “0-9” (for example,
0x11AA22BB33) for each Key used.
or
• Enter 5 ASCII characters (case sensitive) ranging from “a-z”, “A-Z” and “0-9” (for
example, MyKey) for each Key used.
If you select WEP-128:
• Enter 26 hexadecimal digits in the range of “A-F”, “a-f” and “0-9” (for example,
0x00112233445566778899AABBCC) for each Key used.
or
• Enter 13 ASCII characters (case sensitive) ranging from “a-z”, “A-Z” and “0-9” (for
example, MyKey12345678) for each Key used.
Key 1~4 Based on your Key Length selection, enter the appropriate length hexadecimal or
ASCII key.
WPA2/WPA2-Mix Authentication Settings
Table 47 SSID > Security Profile > Add/Edit Security Profile (continued)
LABEL DESCRIPTION
To Next Page
Loading...
