ZyXEL Communications P-2000W_V2 - Setting up Wep on Your Phone (Optional)

ZyXEL P-2000W Quick Start Guide
4 Setting Up WEP on your Phone (Optional)
If you use Wired Equivalency Protection (WEP) to protect wireless traffic on your network, follow
these steps to connect your P-2000W to your wireless network:
! Continuing from the previous section, press the Left
Selector key
to choose your wireless network.
The phone will display “OK” and return to the Wireless
Menu.
! Scroll to 6.WEP Select using the Up Arrow key
and press the Left Selector key
.
! Scroll to either [2] 64-bit or [3] 128-bit security for your
WEP encryption mode. The WEP encryption mode must
match that of your wireless network. Press the Left
Selector key
to make your selection. The phone
will dis
p
la
y
“OK” and return to the Wireless menu.
! Scroll to 7.WEP key 1 using the Down Arrow key
and press the Left Selector key
(most networks
use WEP key 1 by default).
! You will enter the WEP key for your wireless network
here. The lower center of the screen shows the keypad
mode display “Aa1@”, with the “A” mode highlighted.
Use the Up and Down Arrow keys
to choose
between modes for uppercase letters (A), lowercase
letters (a), numbers (1), or symbols (@).
Page 13