ZyXEL P-2000W Quick Start Guide
1 Charge your Phone
! Remove the battery cover. Press down
on the silver button and slide the battery
cover with your other hand as shown.
! Insert battery as shown. Insert the
bottom of the battery first, and push the
top of the battery into the phone.
! Place the battery cover back on as
shown. Then, slide the cover towards
the top until it clicks into place.
! To charge your phone, remove the gray
rubber cover on the bottom of the phone.
Plug the included power adapter into a
wall outlet, and plug the other end into
the phone’s power jack as shown below.
The OK key
on the phone will turn
bright red.
! The included battery comes fully depleted and takes 2 hours to fully charge. When fully
charged, the red OK key
will turn off.
! You can still setup and use the phone while it is charging.
! Once the phone is fully charged, the battery provides approximately 3.5 hours of talk time,
and 21-22 hours of standby time. Please remember to reconnect the phone to its power
adapter when not in use.
Page 8
To Next Page
Loading...