P-660HN-51
5
• The POWER light blinks while your P-660HN-51 starts up and then
stays on once it is ready. The DSL light turns on when the P-
660HN-51 has a DSL connection. The WPS light turns on when the
wireless LAN is ready. The INTERNET light turns on when the
gateway is able to access the Internet and will blink when the P-
660HN-51 is sending or receiving data.
• Each LAN light stays on if the corresponding LAN port is properly
connected and blinks when there is traffic.
If the POWER, DSL, or connected LAN lights are not on, please check
your connections and inspect your cables for damage. If the lights are
still off, contact technical support.
Set Up a Wireless Network
The wireless LAN on your P-660HN-51 is enabled by default. To add a
wireless client to the network, refer to the settings sticker that comes with
your P-660HN-51, which will look similar to the following example:
Configure wireless devices that you want to connect to the wireless
network to use the same wireless settings as the P-660HN-51.
The default wireless settings vary for each P-660HN-51. Refer to the
settings sticker of your device and use the provided information.
SSID: ZyXEL00561
WPA: FB373BD356
To Next Page
Loading...
Need help?
General
