ZyXEL Communications P-791R V2 - Page 87

P-791R v2 Support Notes
The Point-to-Point Protocol (PPP) Bridging Control Protocol (BCP) Spanning
Tree Configuration Option contains an 8-bit Protocol field which identifies the
spanning tree used. These are assigned as follows:
Protocol Spanning Tree
------------------------------------------------------------------------------------
0 Null - no spanning tree protocol supported
1 IEEE 802.1D spanning tree protocol
2 IEEE 802.1G extended spanning tree protocol
3 IBM source route spanning tree protocol
4 DEC LANbridge 100 spanning tree protocol
• PPP INTERNETWORK PACKET EXCHANGE CONTROL
PROTOCOL (IPXCP)
IPXCP CONFIGURATION OPTIONS
Option Description Reference
----------------------------------------------------------------------------------
1 IPX-Network-Number [RFC1552]
2 IPX-Node-Number [RFC1552]
3 IPX-Compression-Protocol [RFC1552]
4 IPX-Routing-Protocol [RFC1552]
5 IPX-Router-Name [RFC1552]
6 IPX-Configuration-Complete [RFC1552]
• IPX COMPRESSION PROTOCOL VALUES
Value Protocol Reference
-----------------------------------------------------------------------
2 Telebit Compressed IPX [Fox]
235 Shiva Compressed NCP/IPX [Fox]
• IPX-ROUTING-PROTOCOL OPTIONS
Value Protocol Reference
-----------------------------------------------------------
0 No routing protocol required [RFC1552]
1 RESERVED [RFC1552]
2 Novell RIP/SAP required [RFC1552]
4 Novell NLSP required [RFC1552]
5 Novell Demand RIP required [RFC1582]
6 Novell Demand SAP required [RFC1582]
7 Novell Triggered RIP required [Edmonstone]
8 Novell Triggered SAP required [Edmonstone]
87
All contents copyright © 2007 ZyXEL Communications Corporation.