ENGLISH
7
3. Press the ENCRYPT buttons at the rear of your powerline devices for
1~2 seconds.
4. While the devices are connecting, the power ( ) and HomePlug
( ) lights blink. Also several times all lights blink at the same time
and the HomePlug ( ) light shows red.
5. Wait for about one minute while your powerline devices connect. The
power ( ) light is steady when the ENCRYPT process times out, the
HomePlug ( ) light is steady if you have a successful connection.
If the power ( ) light does not blink, you have probably
pressed the ENCRYPT button for too long. Try again,
pressing the ENCRYPT button for 1~2 seconds.
If the HomePlug ( ) lights on both powerline devices do
not light up, the powerline devices are not connected.
Repeat steps 2 and 3 in this section. If that doesn’t work,
see the User’s Guide for more suggestions.
2 SEC.
WITHIN
120 SEC.
PRESS
PRESS
2 SEC.
A
B
C
To Next Page
Loading...
