ZyXEL Communications PLA4101 - Removing a Device from a Powerline Network

Chapter 2 The RESET/ENCRYPT Button
PLA Series User’s Guide
14
Figure 4 Adding More Powerline Adapters to Your Network
This sets up your powerline network between your powerline devices.
2.3 Removing a Device from a Powerline Network
Suppose you want to remove PLAs (C) and (D) from the following powerline network.
Figure 5 Removing Devices From an Existing Powerline Network
1 Press the RESET/ENCRYPT button on powerline device C for 5 to 8 seconds and then release it.
This disconnects C from the current network.
2 Press the RESET/ENCRYPT button on powerline device D for 5 to 8 seconds and then release it.
This disconnects D from the current network.
A
B
C
A OR B
D
A OR B OR C
A
C
B
D