Chapter 5 Powerline Network Setup Tutorial
PLA Series User’s Guide
40
Figure 22 Add a Printer to Your Powerline Network
Note: You do not need to know the network name of the new adapter to add it to your
network.
1 Connect your computer to the powerline adapter you want to add to your network and open the
ZyXEL PLA Series Configuration utility (see Section 5.3 on page 39).
2 Go to the Configuration screen. On this screen in the Site column your new powerline adapter
should appear as Local (A). Check the Local adapter’s MAC address (B). It should match the MAC
address listed on the label on the back of your powerline adapter.
Figure 23 Adding a New Adapter
3 Select your adapter by selecting Local and type the network name for your existing network in the
Network Name field (C).
To Next Page
Loading...
