Chapter 3 The RESET/ENCRYPT Button
PLA4211 User’s Guide
20
For example, you have already set up a powerline network in your home (A) which accesses a
printer (B). Now you want a separate powerline network connection from your laptop to your
printer (C).
Figure 9 One Existing Powerline Network
1 Click the RESET/ENCRYPT button on (A) for 5 to 8 seconds and then release it. This disconnects
(A) from (B).
2 Click the RESET/ENCRYPT button on (A) and (C) for 0.5 to 3 seconds and within two minutes of
each other.
3 Wait for about one minute while (A) and (C) connect.
4 Check the LEDs on both (A) and (C). When the power ( ) and HomePlug ( ) lights stop blinking
and the power ( ) light shines steadily, the devices are connected.
Figure 10 Two Separate Powerline Networks
To Next Page
Loading...
