Chapter 2 RESET and ENCRYPT Buttons
PLA6457 User’s Guide
15
Figure 6 Two Separate G.hn Networks
If the Powerline ( ) lights on both PLAs do not light up, the PLAs are not connected. Repeat the
connection process, making certain you press the ENCRYPT buttons for the correct time and
within 2 minutes of each other. If that does not work see Section 5.4 on page 36 for suggestions.
See Troubleshooting in Chapter 5 on page 36 for suggestions on problems with the ENCRYPT button and
the lights.
2.4 RESET Button
The RESET button allows you to reset the PLA to the factory defaults. It also unpairs the PLA from a
network.
The following table summarizes the actions that occur when the RESET button is pressed for specific
lengths of time.
Note: The domain name is unknown when you use the RESET button. You can then pair the
PLA to a different network.
See Troubleshooting in Chapter 5 on page 36 for suggestions on problems with the ENCRYPT button and
the lights.
Table 5 RESET
TIME ACTION POWER LIGHT BEHAVIOR POWERLINE LIGHT BEHAVIOR
10 to 15
seconds
Clear all user-entered
configuration information and
return the device to its factory
defaults.
The power ( ) light blinks and
then shines steadily.
The Powerline ( ) light turns
off when it disconnects from the
G.hn Network.
To Next Page
Loading...
