ZyXEL Communications PLA6457 - Page 24

Chapter 3 Web Configurator
PLA6457 User’s Guide
24
Figure 12 Device Screen
The following table describes the labels in this screen. After you see the firmware updating screen, wait 2
minutes before logging into the PLA again.
Table 9 Device Screen
LABEL DESCRIPTION
Hardware information
Device name This field displays the PLA system name. It is used for identification.
Device
description
This field shows that this is a G.hn bridge PLA.
Device
manufacturer
This field displays the manufacturer of this PLA.
Serial number This field displays the manufacturer assigned number of this PLA.
MAC address This field displays the Ethernet adapter MAC (Media Access Control) address of this PLA.
HW version This field displays the hardware version number of this PLA.
Software information
FW version This field displays the current version of the firmware inside this PLA.
System uptime This field displays how long the PLA has been running since it last started up. The PLA starts up
when you plug it in, or when you reset it.
Security
New
Configuration
password
Type your new Web Configurator password. The password must consist of 6 to 64 characters,
including 0 to 9 and a to z (case sensitive). Note that as you type a password, the screen
displays a (*) for each character you type. Then click Ok. After you change the password, use
the new password to access the PLA.
HTTP SW update