Chapter 4 G.hn Network Setup Tutorial
PLA6457 User’s Guide
31
Note: You do not need to know the domain name of the new adapter to add it to your
network.
1 Connect your computer to the PLA you want to add to your network and open the Web Configurator
(see Section 4.3 on page 29).
2 Go to the G.hn screen. On this screen in the Device ID field your new PLA should appear as 1 (A). Check
the Device ID 1 adapter’s MAC address (B). It should match the MAC address listed on the label on the
back of your PLA.
Figure 19 Adding a New Adapter
3 Type the password for your existing network in the Pairing password field (C). Then click PAIR (D).
4 Your new adapter will now have the same Domain Name as your existing network and so has now
joined your existing network.
5 Connect the adapter’s Ethernet port to the device’s LAN port to add the device to the network, for
example, your Internet refrigerator in the kitchen.
6 Plug the adapter into a power outlet.
7 Repeat this procedure for all additional PLAs that you want to add to your existing or new G.hn network.
To Next Page
Loading...
