Chapter 37 Diagnostic
SBG3300-N Series User’s Guide
287
Note: This screen is available only when you configure an ATM layer-2 interface.
Figure 166 Maintenance > Diagnostic > OAM Ping
The following table describes the fields in this screen.
Table 128 Maintenance > Diagnostic > OAM Ping
LABEL DESCRIPTION
Select a PVC on which you want to perform the loopback test.
F4 segment Press this to perform an OAM F4 segment loopback test.
F4 end-end Press this to perform an OAM F4 end-to-end loopback test.
F5 segment Press this to perform an OAM F5 segment loopback test.
F5 end-end Press this to perform an OAM F5 end-to-end loopback test.
To Next Page
Loading...
