ZyXEL Communications UAG5100 - Page 27

27/29
www.zyxel.com
© Copyright 1995-2017, ZYXEL Communications Corp. All rights reserved.
open in order to see when the firmware recovery finishes.
 Set your computer to use a static IP address from 192.168.1.2 ~ 192.168.1.254.
No matter how you have configured the UAG’s IP addresses, your computer
must use a static IP address in this range to recover the firmware.
 Connect your computer to the UAG’s port 1 (the only port that you can use for
recovering the firmware).
 Use an FTP client on your computer to connect to the UAG. This example
uses the ftp command in the Windows command prompt. The UAG’s FTP
server IP address for firmware recovery is 192.168.1.1
 Log in without user name (just press enter).
 Set the transfer mode to binary. Use “bin” (or just “bi” in the Windows
command prompt).
 Transfer the firmware file from your computer to the UAG (the command is
“put 410AAPN0C0.bin” in the Windows command prompt).
 Wait for the file transfer to complete.
 The console session displays “Firmware received” after the FTP file transfer is
complete. Then you need to wait while the UAG recovers the firmware (this
may take up to 4 minutes).