ZyXEL Communications USG210 - Behavior of the Device HA Pro

222/255
www.zyxel.com
Behavior of the Device HA Pro
The behavior of the Device HA Pro includes a heartbeat link to monitor the “activate”
device’s interface status. If one of the monitored interfaces is dead or fails, the
“passive” device’s status will became “activate”. (This means only 1 device’s status
can be “activate” at a time.)
Device-HA Pro Settings:
A. Enable configuration provisioning on the activated device
--This function is for the secondary device. If you are configuring the
primary device, this function is unnecessary.
B. Serial number of the licensed device for license synchronization
--Entering the serial number of license from the myZyXEL.com server.
C. Configure the Device HA Pro interface
-- Enter the management IP address of the active and passive devices.
Also, enter the password for synchronizing configuration with each
other.
D. Monitoring Interfaces
--Select the interfaces which you would like to monitor.
E. Synchronization
-- Enable failover when one of the interfaces fails.
Figure 338