ZyXEL Communications USG210 - Setting up the Ipv6 Interface

232/255
www.zyxel.com
Setting Up the IPv6 Interface
Wan
1. In the CONFIGURATION > Network > Interface > Ethernet screen’s IPv6
Configuration section, double-click the wan1.
2. The Edit Ethernet screen appears. Select Enable Interface and Enable IPv6. Select
Enable Auto-Configuration. Click OK.
Note: Your ISP or uplink router should enable router advertisement.
Figure 347
Lan
1. In the CONFIGURATION > Network > Interface > Ethernet screen, double-click the
lan1 in the IPv6 Configuration section.
2. The Edit Ethernet screen appears. Select Enable Interface and Enable IPv6. Select
Enable Router Advertisement and click Add and configure a network prefix for the
LAN1 (2006:1111:34ba:1111::/64 in this example). Click OK.