ZyXEL Communications USG210 - Test the Ipsec VPN Tunnel

95/255
www.zyxel.com
Enter the command line in terminal mode (Using Tera Term in this example).
Figure 154 Tera Term command
Test the IPSec VPN Tunnel
14 Go to ZYWALL/USG CONFIGURATION > VPN > IPSec VPN > VPN Connection,
click Connect on the upper bar. The Status connect icon is lit when the interface is
connected.
Figure 155 CONFIGURATION > VPN > IPSec VPN > VPN Connection
15 Go to ZyWALL/USG MONITOR > VPN Monitor > IPSec and verify the tunnel Up Time
and Inbound(Bytes)/Outbound(Bytes) Traffic.
Figure 156 MONITOR > VPN Monitor > IPSec
16 Go to ZyWALL/USG_Branch MONITOR > Log. Try to disconnect WAN1 interface
(172.1.1.30.68) and you will see the VPN tunnel failover to WAN2 interface
(172.100.20.78).