Chapter 1 Introducing the Device
VMG4380-B10A / VMG4325-B10A User’s Guide
22
1.6 The RESET Button
If you forget your password or cannot access the web configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the password will be reset to “1234”.
1 Make sure the POWER LED is on (not blinking).
ETHERNET
WAN
Green On The Gigabit Ethernet connection is working.
Blinking The Device is sending or receiving data to/from the Gigabit
Ethernet link.
Off There is no Gigabit Ethernet link.
DSL1,2 Green On The ADSL line is up.
Blinking The Device is initializing the ADSL line.
Off The ADSL line is down.
Orange On The VDSL line is up.
Blinking The Device is initializing the VDSL line.
Off The VDSL line is down.
INTERNET Green On The Device has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by
a DHCP server), PPP negotiation was successfully completed (if
used) and the DSL connection is up.
Blinking The Device is sending or receiving IP traffic.
Off There is no Internet connection or the gateway is in bridged
mode.
USB Green On The Device recognizes a USB connection.
Blinking The Device is sending/receiving data to /from the USB device
connected to it.
Off The Device does not detect a USB connection.
HPNA Green On The Device is connected to an HPNA-equipped device through
the coaxial cable.
A
Blinking Data is transmitting over the HPNA cable.
Off No HPNA device is connected.
WLAN/WPS Green On The wireless network is activated.
Blinking The Device is communicating with other wireless clients.
Green
and
Orange
Blinking The Device is setting up a WPS connection.
Off The wireless network is not activated.
A. HPNA-equipped models only.
Table 1 LED Descriptions (continued)
LED COLOR STATUS DESCRIPTION
To Next Page
Loading...
