ZyXEL Communications VMG4325-B10A - Page 282

Chapter 35 Diagnostic
VMG4380-B10A / VMG4325-B10A User’s Guide
282
Note: This screen is available only when you configure an ATM layer-2 interface.
Figure 151 Maintenance > Diagnostic > OAM Ping Test
The following table describes the fields in this screen.
Table 113 Maintenance > Diagnostic > OAM Ping Test
LABEL DESCRIPTION
Select a PVC on which you want to perform the loopback test.
F4 segment Press this to perform an OAM F4 segment loopback test.
F4 end-end Press this to perform an OAM F4 end-to-end loopback test.
F5 segment Press this to perform an OAM F5 segment loopback test.
F5 end-end Press this to perform an OAM F5 end-to-end loopback test.