ZyXEL Communications VMG8324-B10A series - Page 110

Chapter 7 Home Networking
VMG8324-B10A / VMG8324-B30A Series User’s Guide
110
3 Click Apply to save your settings.
Figure 56 Network Setting > Home Networking > LAN Setup
The following table describes the fields in this screen.
Table 31 Network Setting > Home Networking > LAN Setup
LABEL DESCRIPTION
Interface Group
Group Name Select the interface group name for which you want to configure LAN settings. See Chapter
12 on page 179 for how to create a new interface group.
LAN IP Setup
IPv4 Address Enter the LAN IPv4 IP address you want to assign to your Device in dotted decimal notation,
for example, 192.168.1.1 (factory default).
Subnet Mask/
Prefix Length
Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your Device automatically computes the subnet mask
based on the IP Address you enter, so do not change this field unless you are instructed to
do so.
IGMP Snooping
Status Select the Enable IGMP Snooping checkbox to allows the Device to passively learn
multicast group.
IGMP Mode Select Standard Mode to have the Device forward multicast packets to a port that joins the
multicast group and broadcast unknown multicast packets from the WAN to all LAN ports.
Select Blocking Mode to have the Device block all unknown multicast packets from the
WAN.
DHCP Server State
DHCP Select Enable to have the Device act as a DHCP server or DHCP relay agent.
Select Disable to stop the DHCP server on the Device.
Select DHCP Relay to have the Device forward DHCP request to the DHCP server.
DHCP Relay
Server Address
This field is only available when you select DHCP Relay in the DHCP field.