Chapter 6 Wireless
VMG8324-B10A / VMG8324-B30A Series User’s Guide
77
In order to configure and enable WEP encryption, click Network Setting > Wireless to display the
General screen, then select Basic as the security level and 802.1X as the Security Mode.
Figure 36 Wireless > General: Basic (802.1X)
The following table describes the labels in this screen.
Table 18 Wireless > General: Basic (802.1X)
LABEL DESCRIPTION
Security Level Select Basic and 802.1X to enable 802.1X data encryption.
Generate
password
automatically
Select this option to have the Device automatically generate a password. The password field
will not be configurable when you select this option.
Password 1~4 The password (WEP key) is used to encrypt data. Both the Device and the wireless stations
must use the same password (WEP key) for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal characters
("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
You must configure at least one password, only one password can be activated at any one
time.
more.../less Click more... to show more fields in this section. Click less to hide them.
WEP Encryption Select 64-bits or 128-bits.
This dictates the length of the security key that the network is going to use.
IP Address Enter the IP address of an external RADIUS server in dotted decimal notation.
To Next Page
Loading...
