Chapter 12 Maintenance
WAP3205 User’s Guide
122
12.3 General Screen
Use this screen to set the management session timeout period. Click
Maintenance > General. The following screen displays.
Figure 74 Maintenance > General
The following table describes the labels in this screen.
12.4 Password Screen
It is strongly recommended that you change your WAP3205's password.
If you forget your WAP3205's password (or IP address), you will need to reset the
device. See Section 12.8 on page 129 for details
Click Maintenance > Password.
Figure 75 Maintenance > Password
Table 42 Maintenance > General
LABEL DESCRIPTION
Administrator
Inactivity Timer
Type how many minutes a management session can be left idle before
the session times out. The default is 5 minutes. After it times out you
have to log in with your password again. Very long idle timeouts may
have security risks. A value of "0" means a management session never
times out, no matter how long it has been left idle (not
recommended).
Apply Click Apply to save your changes back to the WAP3205.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
