Chapter 5 Universal Repeater Mode
WAP3205 User’s Guide
47
7 To set your WAP3205 to Universal Repeater Mode, on the left of the screen,
click Maintenance > Sys OP Mode and select Universal Repeater Mode.
Figure 19 Changing to Universal Repeater mode
Note: You have to log in to the Web Configurator again when you change modes. As
soon as you do, your WAP3205 is already in Universal Repeater mode.
Note: The universal repeater mode IP address is always the same as the access point
mode IP address. If you changed the IP address of your WAP3205 while in
access point mode, use this IP address in universal repeater mode.
To Next Page
Loading...
