Chapter 1 Introducing the Zyxel Device
VMG/XMG Series User’s Guide
54
1.4.3.1 Transceiver Installation
Use the following steps to install an SFP transceiver.
1 Locate the transmit (Tx) and the receive (Rx) markings on the SFP+ module to identify the top.
2 Insert the transceiver into the slot.
3 Press the transceiver firmly until it clicks into place.
4 The Zyxel Device automatically detects the installed transceiver. Check the LEDs to verify that it is
functioning properly.
5 Close the transceiver’s latch (the latch styles vary).
6 Connect the fiber optic cables to the transceiver.
1.4.3.2 Transceiver Removal
Use the following steps to remove an SFP transceiver.
1 Remove the fiber optic cables from the transceiver.
2 Open the transceiver’s latch (the latch styles vary).
3 Pull the transceiver out of the slot.
1.4.4 Using the WLAN and WPS Buttons
If the wireless network is turned off, press the WiFi button. Check the WLAN/WPS LED on the front panel to
see if the wireless network is active.
You can also use the WPS button to quickly set up a secure wireless connection between the Zyxel
Device and a WPS-compatible client by adding one device at a time.
To activate WPS:
1 Make sure the POWER LED is on and not blinking.
2 Press the WPS button and release it.
3 Press the WPS button on another WPS-enabled device within range of the Zyxel Device. The WLAN/WPS
LED flashes amber while the Zyxel Device sets up a WPS connection with the other wireless device.
4 Once the connection is successfully made, the WLAN/WPS LED shines blue or green.
Note: If your Zyxel Device supports both 2.4 GHz and 5 GHz wireless networks, the connection
to the 2.4 GHz wireless network has priority.
To turn off the wireless network, press the WiFi button. The WLAN/WPS LED turns off when the wireless
network is off.
To Next Page
Loading...
