Chapter 4 Tutorials
VMG/XMG Series User’s Guide
98
4 Configure the Static Route Setup screen using the following settings:
4a Click the Active button to enable this static route. When the switch goes to the right ( ), the
function is enabled. Enter the Route Name as R.
4b Set IP Type to IPv4.
4c Type the Destination IP Address 192.168.10.0 and IP Subnet Mask 255.255.255.0 for the destination,
N2.
4d Click the Use Gateway IP Address button to enable this function. When the switch goes to the right
( ), the function is enabled. Type 192.168.1.253 (R’s N1 address) in the Gateway IP Address field.
4e Select VDSL as the Use Interface.
4a Click OK.
Now B should be able to receive traffic from A. You may need to additionally configure B’s firewall
settings to allow specific traffic to pass through.
To Next Page
Loading...
