Chapter 45 Spanning Tree Protocol
XMG1915 Series User’s Guide
246
If you do not configure the auto path cost values for User-defined mode, the Switch uses the following
default values.
Use the this screen to activate one of the STP modes on the Switch. Click SWITCHING > Spanning Tree
Protocol > Spanning Tree Setup to display the screen as shown.
Figure 171 SWITCHING > Spanning Tree Protocol > Spanning Tree Setup
Table 131 Auto Path Cost Mode: User-defined
LINK SPEED AUTO PATH COST VALUE
Up to 10 Mbps 2000000
Up to 100 Mbps 200000
Up to 1 Gbps 20000
Up to 2.5 Gbps 8000
Up to 5 Gbps 4000
More than 5 Gbps 2000
To Next Page
Loading...
