Need help?Do you have a question about the ZyXEL Communications XS1920 Series and is the answer not in the manual?
General| Series | XS1920 Series |
|---|---|
| Model | XS1920-12 |
| MAC Address Table | 16K |
| Management | Web GUI, CLI |
| Layer | Layer 2 |
| VLAN Support | Up to 4K VLANs |
| Quality of Service (QoS) | 8 priority queues |
| Security Features | MAC filtering |
| Power Supply | Internal |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -40°C to 70°C |
| Humidity | 10% to 95% (non-condensing) |
Introduces the main features and applications of the Switch XS1920 Series.
Provides instructions on how to install and connect the Switch.
Describes the front and rear panels of the Switch and shows how to make hardware connections.
Details on accessing the Switch's web-based management interface.
Recommends changing the default administrator password for security.
Explains how to save configuration changes to nonvolatile memory.
Provides steps to reset the Switch back to its factory defaults.
Guides through configuring port-based or tagged VLANs for traffic confinement.
Explains how to use PVID to tag incoming untagged frames for VLAN forwarding.
Details on configuring the Switch's IP address for management purposes.
Provides a step-by-step guide for configuring DHCP snooping.
Guides on configuring the Switch to forward DHCP client requests to a specific server.
Describes the ZON Utility for deploying and managing network devices efficiently.
Allows viewing and managing the Switch's neighboring devices using LLDP.
Explains the concept of Virtual Local Area Networks (VLANs) for network segmentation.
Covers configuration of Switch IP address, default gateway, and management VLAN ID.
Provides information on viewing IPv6 interface status and configuring management IPv6 addresses.
Guides on configuring static VLANs for network segmentation.
Sets up static VLAN (IEEE 802.1Q) configurations on individual ports.
Explains how to assign static MAC addresses for ports to control traffic forwarding.
Details on configuring rules to forward specific multicast frames to designated ports.
Provides steps to create rules for traffic filtering based on MAC addresses and VLANs.
Guides on activating STP modes like RSTP, MRSTP, or MSTP on the Switch.
Details on configuring Rapid Spanning Tree Protocol (RSTP) settings.
Details on limiting the maximum bandwidth for incoming and/or out-going traffic flows.
Guides on activating IEEE 802.1x security features for port authentication.
Explains configuring DHCP relay for clients not in the same broadcast domain.
Guides on upgrading the Switch's firmware to the latest version.
Resets the Switch to its factory defaults, including IP address and passwords.
Provides solutions for problems related to accessing the Switch and logging in.
Details the DHCPv6 protocol for assigning IPv6 network addresses and configuration.
Provides critical safety precautions for using the product.
To Next Page