ZyXEL Communications XS1920 Series - Loop Guard Setup

Chapter 27 Loop Guard
XS1920 Series User’s Guide
237
Figure 166 Loop Guard - Network Loop
Note: After resolving the loop problem on your network you can re-activate the disabled
port via the web configurator (see Section 8.7 on page 69).
27.2 Loop Guard Setup
Click Advanced Application > Loop Guard in the navigation panel to display the screen as
shown.
Note: The loop guard feature can not be enabled on the ports that have Spanning Tree
Protocol (RSTP, MRSTP or MSTP) enabled.
Figure 167 Advanced Application > Loop Guard
A
P
P
N
P