ZyXEL Communications ZyWALL 2 Plus - Page 29

destaddr-single <ip
address>
Select and edit a destination address of a packet which
complies to this rule
destaddr-subnet <ip
address> <subnet
mask>
Select and edit a destination address and subnet mask if a
packet which complies to this rule.
destaddr-range
<start ip address>
<end ip address>
Select and edit a destination address range of a packet
which complies to this rule.
tcp destport-single
<port#>
Select and edit the destination port of a packet which
comply to this rule. For non-consecutive port numbers,
the user may repeat this command line to enter the
multiple port numbers.
tcp destport-range
<start port#> <end
port#>
Select and edit a destination port range of a packet which
comply to this rule.
udp destport-single
<port#>
Select and edit the destination port of a packet which
comply to this rule. For non-consecutive port numbers,
users may repeat this command line to enter the multiple
port numbers.
udp destport-range
<start port#> <end
port#>
Select and edit a destination port range of a packet which
comply to this rule.
desport-custom
<desired custom port
name>
Type in the desired custom port name
custom-ip <desired
custom service
name>
Type in the desired User Defined IP Protocol custom
service.
custom-icmp
<desired custom
service name>
Type in the desired ICMP custom service
delete firewall e-mail Remove all email alert settings
attack Reset all alert settings to defaults
set <set#> Remove a specified set from the firewall configuration
set <set#> rule <rule#> Remove a specified rule in a set from the firewall
configuration
insert firewall e-mail Insert email alert settings
attack Insert attack alert settings
set <set#> Insert a specified rule set to the firewall configuration
set <set#> rule <rule#> Insert a specified rule in a set to the firewall
configuration
cli Display the choices of command list.
IP Related Command Home
Command FLag Description
ip
address [addr] display host ip address
alias <iface> R alias iface
aliasdis <0|1> R disable alias
alg
disp Show ALG enable disable status
enable <ALG_FTP|ALG_H323|ALG_SIP> Enable ALG command
disable <ALG_FTP|ALG_H323|ALG_SIP> Disable ALG command
siptimeout <timeout in second> or 0 for no timeout Configure SIP timeout command
arp
status <iface> display ip arp status
dhcp <iface> R