ZyXEL Communications ZYWALL 35 - Page 5

ENGLISH
5
Check the
Network
Status table.
If the WAN 1
status is not
Down and
there is an IP
address, go
to Section 5.
If the WAN 1
status is
Down (or
there is not an
IP address),
click the
Wizard icon
and use
Section 4 to
configure
WAN 1.
Use the NETWORK WAN screens if you need to configure WAN 2. You can also configure load balancing
between the WAN ports.
3 Bridge Mode
When you set the ZyWALL to bridge mode, it functions as a transparent firewall. Do the following to set the
ZyWALL to bridge mode.