ZyWALL 5 Support Notes
All contents copyright (c) 2006 ZyXEL Communications Corporation.
152
11. On Local Network, choose Subnet Address for your Address Type. Starting IP Address and
Ending IP Address/Subnet are your local site LAN IP addresses. In this example, you should
type 192.168.1.0 on Starting IP Address field and then type 255.255.255.0 on Ending IP
Address/Subnet field.
12. On Remote Network, choose Subnet Address for your Address Type. Starting IP Address and
Ending IP Address/Subnet are your remote site LAN IP addresses. In this example, you should
type 192.168.2.0 on Starting IP Address field and then type 255.255.255.0 on Ending IP
Address/Subnet field.
13. On IPSec Proposal, select Encapsulation Mode to Tunnel, Active Protocol to ESP,
Encryption Algorithm to DES and Authentication Algorithm to SHA1, and then press Apply
button on this page.
To Next Page
Loading...
