ZyWALL 5 Support Notes
All contents copyright (c) 2006 ZyXEL Communications Corporation.
35
Key Settings:
Active
Check the box to enable BWM on the interface. Note that if you would like to manage
traffic from WAN to LAN, you should apply BWM on LAN interface. If you would like
to management traffic from WAN to DMZ, please apply BWM on DMZ interface.
Speed
Enter the total speed to manage on this interface. This value is the budget of the class
tree's root.
Scheduler
Choose the principle to allocate bandwidth on this interface. Priority-Based allocates
bandwidth via priority. Fairness-Based allocates bandwidth by ratio.
Maximize
Bandwidth
Usage
Check this box if you would like to give residuary bandwidth from Interface to the
classes who need more bandwidth than configured amount. Do not select this if you
want to reserve bandwidth for traffic that does not match a bandwidth class or you want
to limit the bandwidth of each class at the configured value. (Please note that to meat the
second condition, you should also disable bandwidth borrowing on the class.)
Go to ADVANCED->BW MGMT->Class Setup, select the interface on which you would like to setup
the Class tree.
Click the radio button besides the Root Class, then press 'Add Sub-Class'
To Next Page
Loading...
