18
TROUBLESHOOTING GUIDE
This section includes a list of frequently asked questions for problems you may encounter with your unit.
If your OWL
TM
is not operating as you think it should, check here before arranging for servicing.
NOTE After resetting the main unit receiver it may take up to 2 minutes to re-establish the communications
link. This can be expedited by pressing the "CHECK" button on the remote transmitter for 2 seconds to force
transmissions every 2 seconds.
SPECIFICATIONS
Dimensions
Remote Monitor (Model CM1
13)
Width x Height x Depth
107 W x 117 H x 30 D mm
Weight 160 g
Sender Box (Model CMR113)
Width x Height x Depth
78 W x 113 H x 40 D mm
Weight 110 g
Sensor (Model CMS113)
Width x Height x Depth
50 W x 50 H x 30 D mm
Weight 20 g
Problem Symptom Check this Remedy
No power or no
reading
Power will not turn on or
no display reading on LCD
screen
Batteries are exhausted.
Replace with new batteries.
Batteries are inserted
incorrectly.
Insert the batteries correctly
(-> Batteries).
“----“ reading “----“ display readings on
LCD screen or, Display does
not change when power use
is changed
Sender Box and Remote
Monitor are not synchro-
nised or transmission link
has been broken
Reset both units, Sender
Box first, Remote monitor
second.
“00.00“ reading Current not detected
Check cable from sensor
into transmitter
Call Electrician to check
No Alarm "----" reading in Alarm
Alarm disabled
Activate alarm
"----" flashing Automatic search underway
-
Allow search to run to
completion
Remote Monitor
receives data from
another Sender
Boxr
Display does not respond as
expected
Incorrect Sender Box
detected during installation
or following battery
replacement or "reset"
R e fe r t o in s ta l l a ti on
instructions
To Next Page
Loading...