2 Save Energy CM113 User Manual

NE
6
WARNINGS
To ensure you use your product correctly and safely, read these Warnings and the User Manual before using
the product. These warnings provide important safety information and should be observed at all times.
WARNINGS
¥
When fitting sensors if in any doubt always contact a qualified electrician.
¥ D o not attempt to repair the product yourself. C ontact the retailer or our customer service department if it
re q uires servicing.
¥ Ta k e precautions when handling all battery types. They can cause in j uries, burns, or property as a result of
contact with conducting materials, heat, corrosive materials or e x plosives. R emove the batteries
before storing the product for long periods of time.
¥ D o not immerse the device in water.
¥ D o not, under any circumstances, touch the e x posed electronic circuitry of the device as there is a danger
of electric shoc k should it become e x posed.
¥ Ta k e special care when handling a damaged LCD display, as the li q uid crystals can be harmful to your health.
¥ D o not use or store the device, including the remote sensor, in locations that may adversely affect the product
such as rain, snow, desert, and magnetic Þ elds.
¥ D o not use this device in aircrafts or hospitals. The use of radio fre q uency products can cause malfunctions in
the control devices of other e q uipment.
¥ D o not sub j ect the product to impact or shoc k .
¥ When disposing of this product, do so in accordance with your local waste disposal regulations.
SAFETY AND CARE INSTRUCTIONS
Safety precautions
P lease observe the following safety precautions when setting up and using this product.
¥ LCD panel Ð The LCD panel is made of glass, and may brea k if the unit is dropped or impacted.
¥ H eat sources Ð K eep the product away from heat sources such as radiators, stoves, heaters, and
other heat - generating products.
¥ W ater and moisture Ð D o not use the product in or near water or in high moisture areas such as a
bathroom.
¥ P ower source Ð The product may be susceptible to power surges, and the S ensor cable should be
disconnected from the S ender B o x during severe storms.
Caring for this product
To ensure you receive the ma x imum bene Þ t from using this product, please observe the following
guidelines.
¥ C leaning Ð D isconnect the S ensor and remove the batteries from the S ender B o x and the R emote
Monitor before cleaning. Use a damp cloth. D o not use li q uid cleaning agents,ben z ene, thinner, or
aerosols.
¥ V entilation Ð The vents and other openings are designed for ventilation and should not be bloc k ed
or covered. B loc k ing the vents can cause the product to overheat and can damage the unit.
¥ R epair Ð D o not attempt to repair the product or modify the circuitry by yourself. C ontact the
retailer
or a q uali Þ ed electrical person if the product re q uires servicing. O nly use replacement parts that are
recommended by the manufacturer.
¥ D o not scratch hard ob j ects against the LCD display as this may cause damage.
¥ D o not leave discharged batteries in either receiver or transmitter unit for any length of time, as they
may lea k and cause corrosion.
!

2 Save Energy CM113 Specifications

General

Brand	2 Save Energy
Model	CM113
Category	Monitor
Language	English