27
7.2. Camera Installation
The camera unit, Part No. 9135210E, can be built into any EntryCom basic unit
during installation or as an option to be added later. You can also use the camera unit in
combination with any Vandal resistant panel. It is a colour CCD camera with high
resolution of 420 TV rows, with a monochrome night mode (infrared backlight hidden
under the nameplates), and has a wide-angle pin-hole lens (90º diagonally) and a tilting
hinge for manual direction adjustment.
The camera has a PAL composite output and can be connected to any TV
display (e.g. Part No. 9134147E - 7" TFT LCD), or a video server (Part No. 9134145E,
MPEG4 LAN video server). A coaxial or twisted cable can be used for connection.
A sight glass is included in the delivery, which replaces the non-transparent
EntryCom basic unit sight glass imitation. To install the camera, follow the instructions
that come with it.
IMPORTANT!
To install the camera, use the stabilised 12 V dc power supply. To get a suitable (12V /
2A) one, order Part No. 91341481E.
7.3. Display Installation
The display module, Part No. 9135240E, can be built into any EntryCom basic
unit (excepting units with vandal resistant panel) during installation or as an option to be
added later. It is black & white, graphic LCD with resolution 128 x 64 pixels, white
backlight and USB interface for configuration.
It has memory for up to 1000 characters, and it is controlled by basic module
buttons and keypad, if present. Each character can be alphanumeric or graphic up to
whole display size.
A sight glass is included in the delivery, which replaces three button labels on
EntryCom basic unit. To install the display, follow the instructions that come with it.
IMPORTANT!
To install the disply, use the stabilised 12 V dc power supply. To get a suitable (12V /
2A) one, order Part No. 91341481E.
To Next Page
Loading...
