2N IP Force 9151101CHW - Page 103

Installation manual 2N® IP Force

103 / 118
•
•
•
•
•
•
•
•
The device will have the following network parameters after restart:
IP address – 192.168.1.100
Network mask – 255.255.255.0
Default gateway – 192.168.1.1
Dynamic IP Address Setting for 4-button models
Follow the instructions below to enable automatic getting of network
parameters from the DHCP server:
Connect2N
®
IP Forceto the power supply (or, disconnect and reconnect it if already connected).
Wait for the first acoustic signal
Press buttons 2, 1, 1, 2, 2, 3 sequentially.

The acoustic signal indicates mode switching.
Wait until the device is restarted automatically.
2N
®
IP Forcegets the IP address upon restart only if the DHCP server is
configured properly.
•
Caution
The 1, 1, 1, 2, 2, 3 sequence must be entered within 30 seconds after the first sound signal for
security reasons. The inter-digit delay may be 2 s at most.

•
Caution
The 2, 1, 1, 2, 2, 3 sequence must be entered within 30 seconds after the first sound signal for
security reasons. The inter-digit delay may be 2 s at most.
