Installing the Power Cable 33
2
Plug the other end of the power module into a surge-protected standard 110 VAC
wall outlet.
The PWR and AA indicator LEDs illuminate. The ALERT LED flashes momentarily as
the unit undergoes a power-up self-test diagnostic. Once completed, only the
PWR LED and LAN port LED remain lit.
This completes the 56K LAN Modem installation.
If you do not have TCP/IP installed and set up on your computer, refer to
Chapter 4, “Setting Up TCP/IP for Windows and Macintosh.” If you already have
TCP/IP installed and set up on your computer, refer to Chapter 5, “Configuring the
56K LAN Modem.”
To Next Page
Loading...