3Com 3C886 - OfficeConnect 56K LAN Modem Router - Installing Analog Equipment; Installing the Power Cable

32 C
HAPTER
3: H
ARDWARE
D
ESCRIPTION AND
I
NSTALLATION
Installing Analog
Equipment
You can connect an analog touch-tone telephone, answering machine, fax
machine, or external analog modem to the 56K LAN Modem’s pass-through
Phone port.
You will need an RJ-11 to RJ-11 cable that came with the analog device for your
analog phone port connection.
To install an analog device:
1
Insert one end of an RJ-11 cable into the port labeled
Phone
on the back of the
56K LAN Modem, as shown in Figure 14.
Figure 14
Analog Equipment Connection
2
Insert the other end of the RJ-11 cable into the appropriate RJ-11 port on the
analog device.
Installing the Power
Cable
To install the power cable:
1
Connect the 56K LAN Modem power module cable to the 10-18 VDC power
connector on the back panel of the 56K LAN Modem, as shown in Figure 15.
Figure 15
Power Cable Connection
RESET
10-18 VDC
0.8 A MAX
LINE PHONE
RESET
10-18 VDC
0.8 A MAX
TELCO PHONE