40 C
HAPTER
4: S
ETTING
U
P
TCP/IP
FOR
W
INDOWS
AND
M
ACINTOSH
If you are using dynamic IP addressing on your LAN and would like your LAN
Modem to act as your DHCP server, select
Yes.
Note that you must select
Yes
if
there is no other DHCP server on your LAN.
6
You are then prompted to insert your installation CD-ROM. Insert the Windows NT
4.0 CD ROM and then click
Continue
.
If you have Remote Access Service (RAS) installed on your PC after the appropriate
files are copied to your PC, a message box asks whether or not you would like
TCP/IP installed for RAS. If you select
Yes
, you must select the device you want to
access remotely and then click
Close
.
7
After the appropriate files are copied to your PC, you will see TCP/IP Protocol listed
in the Network Protocols group box, as shown in Figure 25.
Figure 25
Network Protocols Window
8
Click
Close.
The Microsoft TCP/IP Properties window appears, as shown in Figure 26.
To Next Page
Loading...